palintest Green Drop Kit Instructions Manual page 25

To Connect the Conductivity/Temperature
Probe:
1 Line up the notch and 6 pins on the probe
connector with the holes in the connector
located on the top of the meter. Push down and
screw the metal sleeve to lock the probe
connector into place. See Figure 4.
2 To remove probe, unscrew the metal sleeve and
slide up the probe connector. While holding
onto metal sleeve, pull probe away from the
meter.
Note: Follow the same directions to connect an
optional separate temperature element.
Caution: Do not pull on the probe cord or the
probe wires might disconnect.