palintest Green Drop Kit Instructions Manual page 22

Key Function
ON/OFF Powers on and shuts off the meter. When you switch on the
meter, the meter starts up in the mode that you last switched
off from. For example, if you shut the meter off in
conductivity measurement mode, the meter will be in
conductivity measurement mode when you switch the meter
on.
HOLD Freezes the measured reading. To activate, press HOLD
while in measurement mode. To release, press HOLD again.
MODE Selects the measurement parameter. Press MODE to toggle
between pH and TDS or conductivity measurement mode.
CAL/ME Toggles between Calibration and Measurement mode.
AS
1. If you are in pH measurement mode, press CAL/MEAS to
enter pH calibration mode.
2. If you are in conductivity measurement mode, press
CAL/MEAS to enter conductivity calibration mode.
3. If you are in TDS measurement mode, press CAL/MEAS
to enter TDS measurement calibration mode.
While in SETUP sub-menu, pressing CAL/MEAS once takes
you out to the SETUP main menu and pressing CAL/MEAS
second time takes you directly into the measurement mode.
ENTER ENTER function: Press to confirm values in Calibration mode
/ and to confirm selections in SETUP mode.
RANGE
RANGE function (for conductivity &TDS measurements only):
Press to enter manual ranging function. The MEAS indicator