palintest Green Drop Kit Instructions Manual page 24

Probe Information
Your meter includes two probes:
 pH electrode with BNC connector.
 conductivity/temperature probe with a notched
6-pin connector
The temperature sensing element built into the
conductivity probe will also compensate for pH
readings as long as both probes are in your
solution at the same time.
Note: Keep connector dry and clean. Do not touch
connector with soiled hands.
To connect the pH electrode:
1 Slide the BNC connector of the probe over the
BNC connector socket on the meter. Make sure
the slots of the connector are in line with the
posts of the socket. Rotate and push the
connector clockwise until it locks.
2 To remove electrode, push and rotate the
connector anti-clockwise. While holding onto
the metal part of the connector, pull it away from
the meter.
Caution: Do not pull on the probe cord or the
probe wires might disconnect.