Inner Bottom Covers; Tools Required; Removal Procedure; Replacement Procedure - Keysight Technologies X Series Service Manual

Assembly Replacement

Inner Bottom Covers

Tools Required

— T-10 driver

Removal Procedure

Refer to
1. Disconnect the power cord.
2. Remove the outer-cover from the signal generator. Refer to
3. Place the signal generator upside down.
4. Refer to
5. Refer to

Replacement Procedure

1. Reverse the order of the removal procedures.
2. Recommended torque for all screws is 9 in–lbs.
Keysight Agile Signal Generator Service Guide
Figure 3-4 and Figure 3-5
on page 99.
Figure 3-4. To remove the rear bottom cover (1), use the T-10
driver to remove the twelve screws (2) (0515-1946) (including two on the
rear panel).
Figure 3-5 To remove the front bottom cover (3), use the T-10
driver to remove the sixteen screws (4) (0515-1946).
for this procedure.
"Outer Cover"
101