A3 Fan Module; Tools Required; Removal Procedure - Keysight Technologies X Series Service Manual

Assembly Replacement

A3 Fan Module

Tools Required

— T-10 driver

Removal Procedure

1. Disconnect the power cord.
2. Remove the outer-cover from the signal generator. Refer to
3. Place the signal generator upside down on a flat surface.
4. Refer to
Figure 3-32 Outer Wall Removal
Keysight Agile Signal Generator Service Guide
on page 99.
Figure 3-32. Using the T-10 driver remove the eleven screws (1)
(0515-1946) that attach the outer wall (2) to the chassis.
"Outer Cover"
135