Remove The Outer And Inner Signal Generator Covers; Remove The Outer Cover; Remove The Inner Top Cover - Keysight Technologies E8251-60384 Installation Notes

Remove the Outer and Inner Signal Generator Covers

Remove the Outer Cover

Refer to Figure 1.
1. Disconnect the power cord.
2. Using a T-20 driver, loosen the two screws (1) and remove the strap handle (2).
3. Using a T-15 driver, remove the center screws (3) on the four rear-panel feet (4).
4. Remove the four bottom feet (5) from the cover by lifting the tab and sliding the foot toward
the tab.
5. Place the signal generator on its side.
6. Tilt the signal generator forward and slide the outer cover (6) back to remove it from the frame.

Remove the Inner Top Cover

Refer to Figure 2.
1. Using a T-10 driver, remove the twelve screws (1) from the inner-top cover (2).
2. Remove the inner-top cover.
Installation Note E8251-90302
Remove the Outer and Inner Signal Generator Covers
7