Section 14 - Troubleshooting - Mec Speed Level 3084ES Operator's Manual

Secton 14 - Troubleshootng
Machine functions will not operate
• Battery Disconnect Switch ON?
• Batteries fully charged?
• Function toggle switch or the enable switch not activated?
• Selector switch in proper position?
• Both EMERGENCY STOP switches reset?
• Hydraulic fluid level low?
• Obvious fluid leak or damaged component?
• Wires disconnected, broken, or loose?
• Motor control processor Diagnostic LED OFF?
• LED should be ON. If LED is OFF or FLASHING, refer to Service Manual or contact MEC
Technical Support.
Page 44
Troubleshooting Troubleshooting
Should you experience erratic operation or notice any malfunction while
operating this machine, discontinue use immediately�����
Call for assistance and report the incident to your supervisor, and do
not use the machine until it has been checked by a trained, qualified
mechanic�����
Lower Controls
GP400
Module
ART_3093
3084ES Speed Level
Terminal
Block
Module
Diagnostic LED
TM - Operator's Manual
August 2020