OperatNg InstructOns - Mec Speed Level 3084ES Operator's Manual

Secton 6 - Functon Tests and Operatng Instructons
DO NOT operate this machine until you have read and understood the Safety section of this
manual, have performed the Pre-Start Inspection, Routine Maintenance, and Functions Test,
have inspected the jobsite for hazards, and have learned the operating procedures for this
machine�����
This section provides instructions for each function of machine operation. Follow all safety rules and
instructions.
This machine may be operated by trained and authorized personnel only. If multiple operators use
this machine, all must be qualified and authorized to use it. New operators must perform a Pre-Start
Inspection (see page 25) and Functions Test prior to operating the machine.
Operators must comply with employer, job site and governmental rules regarding the use of personal
protective equipment – see "Fall Protection" on page 3.
Prestart
ART_2506 R2
ART_2507 R2
ART_2356
Note: If machine fails to operate, check the Diagnostic LED on the motor
ART_2755 R1
Page 14
Operating Instructions
Perform Pre-Start Inspection (see page 25).
Check base control EMERGENCY STOP switch – turn clockwise to reset.
Check platform control EMERGENCY STOP switch – turn clockwise to reset.
Check Battery Disconnect switch in control module next to lower control box.
Must be in ON position.
Check Charge Indicator on base control panel. Battery pack should be fully
charged.
control processor inside the control module – see "Component
Locations" on page 36.
3084ES Speed Level TM - Operator's Manual
August 2020