Machine Inspections - Mec Speed Level 84RT Series Operator's Manual

84RT Series Speed Level™

Machine Inspections

DO NOT operate this machine until you have read and understood the Safety section of this manual, have performed the
Pre-Start Inspection, Routine Maintenance, and Functions Test, have inspected the jobsite for hazards, and have learned the
operating procedures for this machine.
The operator must conduct a thorough Pre-Start Inspection of the machine and test all functions before each work shift to check for
damage, malfunction and unauthorized modification.
Tag and remove a damaged, malfunctioning or modified machine from service. DO NOT use a damaged, malfunctioning or modified
machine.
Use the Pre-Start Inspection to determine what Routine Maintenance is required. The operator may perform only the routine
maintenance items specified in this manual.
IMPORTANT— Scheduled maintenance inspection checklists are included in this manual for use only by qualified service
technicians. Only qualified service technicians may perform repairs to the machine. After repairs are completed,
the operator must perform a Pre-Start Inspection before proceeding to the Functions Test.
Never perform service on the machine with the platform elevated without first blocking the elevating
assembly (see Maintenance Safety on page 28).
Never leave hydraulic components or hoses open. They must be protected from contamination
(including rain) at all times.
Never open a hydraulic system when there are contaminants in the air.
Always clean the surrounding area before opening hydraulic systems.
Use only recommended lubricants. Improper lubricants or incompatible lubricants may be as harmful
as no lubrication.
Watch for makeshift "fixes" which can jeopardize safety as well as lead to more costly repair.
Hydraulic fluid under pressure can penetrate and burn skin, damage eyes, and may cause serious
injury, blindness, and even death. Correct leaks immediately.
Failure to perform preventive maintenance at recommended intervals may result in the unit being
operated with a defect that could result in injury or death of the operator.
Immediately report to your supervisor any Defect or malfunction. Any defect shall be repaired prior to
continued use of the aerial work platform.
Inspection and maintenance should be performed by qualified personnel familiar with the equipment.
Fluid leaks under pressure may not always be visible. Check for pin hole leaks with a piece of
cardboard, not your hand.
Page 22
Machine Inspections
91857rev2– February 2013