Creating Model Trunks And Changing Route Access Codes; Creating Model Trunks - Nortel Meridian 1 Option 11C Planning And Installation Manual

Creating model trunks and changing route access codes

Creating model trunks

TYPE XXXX M "XXXX" = telephone type for the model
you are removing (Example: 500, 2006,
2317, 2216, 3000, etc.)
CUST 0
MODL YYY "YYY" = the model number associated
with the telephone type you are removing
(Valid range is 1-127).
If you need a trunk that is different from the default models provided in
Option 11 software, use overlay 14 to design your own models. Route access
codes are changed using the administration telephone.
If you require additional assistance when creating your own model telephones
and trunks, refer to the Option 11 Software guides that are shipped with every
system.
To create a new model trunk, load LD 14 and type in the following commands
on the TTY:
LD 14
REQ NEW
TYPE aaa M "aaa" = the type of trunk that you are
creating (TIE, COT, WATS, and so on).
MODL YYY "YYY" = the model number of the trunk that you are creating
(between 1 - 127)
XTRK XUT, XEM, XCOT, This prompt only appears when you
XDID define the first model in a group. Each
group consists of 16 consecutive model
definitions. (Refer to the group boundaries
listed below.) Once the first model in a
group is defined, the remaining model
numbers in the group(s) are assumed to
be of the same type.
Changing pre-programmed data Page 401 of 408
Option 11C Planning and Installation Guide