Modifying Model Trunks; Removing Model Trunks - Nortel Meridian 1 Option 11C Planning And Installation Manual

Page 402 of 408 Changing pre-programmed data

Modifying model trunks

Removing model trunks

553-3021-210 Standard 7.00
Group boundaries are as follows:
1-15, 16-31, 32-47, 48-63, 64-79. 80-95, 96-111, 112-127.
Examples:
If, for example, you define a model trunk as XUT, with a model number of
12, all models in the group 1-15 will automatically be XUT models. If you
define another model trunk as an XEM, with a model number of 33, all
models in the group 32-47 will automatically be XEM models.
Note: When you create trunk models you are not prompted for the trunk
route or member number. This information is defined by using the
administration telephone to program the XUT or XEM circuit card.
For more information about LD 14 and its associated prompts and
commands, refer to the Option 11 Software guides that are shipped with the
system.
If you want to modify a trunk, load LD 14 and type in the following
commands on the TTY:
LD 14
REQ CHG
TYPE aaa M "aaa" = the type of trunk that you are
modifying
MODL YYY "YYY" = the model number of the trunk
that you are modifying (between 1 - 127)
To remove a trunk model from the system, load LD 14 and respond to the
prompts as follows:
LD 14
REQ OUT
TYPE XXX M "XXX" = the trunk type of the model that
you are removing (Examples: COT, TIE,
DID, FEX, WAT, etc.)
January 2002