Activating A Customized Model With A Character Display - Nortel Meridian 1 Option 11C Planning And Installation Manual

If the extension number is not available for use, you hear a fast,
high-pitched broken tone (overflow tone). (This happens when you
choose an extension number manually or when extension numbers
are entered for additional keys. A default extension number will not be
offered if it is not available). Step 3 must be repeated and you must
manually enter a new extension number.
Note: If other keys require secondary extension numbers, you are
prompted until you enter all of the required extension numbers for the
model. These extension numbers cannot be defaulted. You are
prompted for each additional extension number with three beeps
followed by continuous dial tone (special dial tone). When you are
programming an extension number, the lamp associated with that
number on the telephone is lit.

Activating a customized model with a character display

Procedure 47
Activating a customized telephone
1 Plug the telephone set into the jack and wait 20 seconds before
picking up the handset. If you do not receive dial tone, replace the
handset and wait another 10 seconds before going off-hook
again. Repeat this procedure until dial tone is received.
If successful, the character display shows either "MODEL? X" (if the
telephone relocation feature is not in use) or "RELOC OR MODEL? X"
(if the telephone relocation feature is in use). "X" represents the default
model for the telephone that you are activating.
Note 1: If you do not see the prompt "MODEL X" after lifting the
handset, disconnect the telephone from the wall jack, wait five
seconds, and re-insert the telephone into the jack. The telephone now
shows "MODEL X" when you lift the handset.
Note 2: The 20 second time interval is required for the system to
determine whether the set is new or if it is being relocated using the
Modular Telephone Relocation feature.
Connecting the telephones Page 273 of 408
Option 11C Planning and Installation Guide