Interference With Call Park Extension Numbers; Interference With Sdi Ports - Nortel Meridian 1 Option 11C Planning And Installation Manual

Page 394 of 408 Changing pre-programmed data

Interference with Call Park extension numbers

Interference with SDI ports

553-3021-210 Standard 7.00
In LD 23, respond to the prompts as follows:
LD 23
REQ OUT
TYPE ACD
CUST 0
ACDN XXXX "XXXX" = Value of ACD queue
Repeat for each ACD queue you wish to remove.
System call park extension numbers are pre-programmed for the Central
Answering Position. (For some countries, the default call part extensions are
listed in "Important extension numbers" on page 318.) To remove this data
from the system, load LD 50 and respond to the prompts as follows:
LD 50
REQ OUT
TYPE CPK
CUST 0
SPDN XXXX "XXXX" = Value of Call Park extension
Repeat for each Call Park extension you wish to remove.
Five SDI/ESDI ports are pre-programmed on the Option 11 system. Ports 8
and 9 are associated with the Meridian Mail card option, and ports 0, 1 and 2
are associated with the NTDK20 Small System Controller (SSC) card. Port 0
is associated with SSC card and cannot be removed. Any of the remaining
ports can be removed using LD 17 as follows.
LD 17
REQ CHG
TYPE CFN
January 2002