EMC Connectrix B Series Hardware Reference Manual page 40

Initial Configuration Parameters
3
3-4
Connectrix B Series XPath OS AP-7420B Hardware Reference Manual
Table 3-1 Ipaddrset Command Variables (continued)
Variable
-s
-r
*Note: These variables use the standard aa.bb.cc.dd format.
To set the IP address as 192.168.10.1, netmask 255.255.255.0, and
gateway 192.168.10.2 of the management interface 1; the switch
virtual IP address; and the netmask:
APswitch:admin>
255.255.255.0
3. Enter the
set correctly.
4. If the console port is no longer required, remove the serial cable
and insert its dust plug.
CAUTION
!
The console port can be used to monitor error messages
through a serial connection. It is not recommended as a
command interface during normal operations. If this port is not
going to be in ongoing use, remove the serial cable and protect
the port from dust by replacing the shipping cap.
Description
Specifies if you want to set the virtual IP
address and netmask to be the same as
the new IP address and netmask
Specifies if you want to reset the IP
configuration of the management
interface
ipaddrset
-g 192.168.10.2 -a cfgnow -s
command to verify that the IP address was
ipaddrshow
1 -i 192.168.10.1 -n