EMC Connectrix B Series Hardware Reference Manual page 19

System
Status
LEDs
0 1
POWER
PORTS
SYSTEM
DC AC
OK OK
Power
Supply
Status
LEDs
Figure 1-1
Power Supplies
Multiprotocol Ports
Fibre Port
Channel Status
Ports (16x) LEDs
2 3 4 5 6 7 8
100-240 VAC 6.0 A 47-63 Hz
DC AC
OK OK
AC Power
Receptacle
Power Power
Supply Supply
(2x) Status
LEDs
AP-7420B (Port Side)
The AP-7420B power supply is a hot-swappable FRU, allowing 1+1
redundant configurations. The unit is a universal power supply
capable of functioning worldwide without voltage jumpers or
switches. The fully enclosed, self-contained unit has internal fans to
provide cooling and is auto-ranging in terms of accommodating
input voltages.
The power supply provides three DC outputs (5V standby, 12V, and
48V), providing a total output power of 320 maximum usable watts.
The power supplies plug directly into the enclosure from the port
side of the unit, mating to internal blind connectors that connect both
the DC outputs and the interface signals to the system backplane. An
integral on/off switch, input filter, and power indicator are provided
in the power supply, as well as a serial EEPROM device that provides
identifying information. Refer to Table 4-4 on page 4-6 for
information about the power supply LEDs.
The Multiprotocol Router has 16 multiprotocol ports (numbered 0
through 15, left to right).
Each of the 16 multiprotocol ports are equipped with an SFP. Each
ASIC in the Multiprotocol Router switch connects to a single SFP
Management
AP-7420B
MGMT2
9 10 11 12 13 14 15
SPEED
FC/GbE
LINK/ACT
100-240 VAC 6.0 A 47-63 Hz
Captive
Screw
scale: 9/32" = 1"
AC
scale: .28125" = 1"
ON/OFF
Switch
Hardware Components
Multiprotocol Router Overview
Management
Ports
Port
(2x)
LEDs
Serial
Port
MGMT1 CONSOLE
ACTIVITY
LINK SPEED
Handle
1
1-5