EMC Connectrix B Series Hardware Reference Manual page 105

Connection Initiator
Connection Recipient
Controller
Core PID
COS
CP
CPLD
CRC
Credit
Cut-through
D_ID
DAS
A port that has originated a Class 1 dedicated connection and
received a response from the recipient.
A port that has received a Class 1 dedicated connection request and
transmitted a response to the originator.
A computer module that interprets signals between a host and a
peripheral device. The controller typically is part of the peripheral
device.
Core Switch Port Identifier. The Core PID parameter must be set for
v3.1 and lower switches that are included in a fabric of v4.1 switches.
This parameter is located in the
versions v3.1 and lower. All v4.1 switches and higher use the core PID
format by default so this parameter is not present in the
command for these switches.
Class of service.
Control processor.
Complex PLD. Alternatively known as Enhanced PLD (EPLD), Super
PAL, and Mega PAL.
Cyclic redundancy check. A check for transmission errors included in
every data frame.
As applies to Fibre Channel, the number of receive buffers available
for transmission of frames between ports. See also BB_Credit and
EE_Credit.
A switching technique that allows the route for a frame to be selected
as soon as the destination address is received. See also Route.
D
Destination identifier. A 3-byte field in the frame header, used to
indicate the address identifier of the N_Port to which the frame is
headed.
Direct-attached storage.
Connectrix B Series XPath OS AP-7420B Hardware Reference Manual
command of firmware
configure
Glossary
configure
g-7