Table of Contents
Advertisement
ENI58PL-S***, ENI58PL-R***
Introduction
1.3
Symbols Used
This document contains symbols for the identification of warning messages and of informative
messages.
Warning Messages
You will find warning messages, whenever dangers may arise from your actions. It is mandatory
that you observe these warning messages for your personal safety and in order to avoid
property damage.
Depending on the risk level, the warning messages are displayed in descending order as
follows:
Danger!
This symbol indicates an imminent danger.
Non-observance will result in personal injury or death.
Warning!
This symbol indicates a possible fault or danger.
Non-observance may cause personal injury or serious property damage.
Caution!
This symbol indicates a possible fault.
Non-observance could interrupt the device and any connected systems and plants, or result in
their complete failure.
Informative Symbols
Note!
This symbol brings important information to your attention.
Action
This symbol indicates a paragraph with instructions. You are prompted to perform an action or
a sequence of actions.
1.4
Intended Use
Incremental rotary encoders in the ENI58PL product family deliver a set number of pulses for
each shaft revolution. Downstream electronics can be used to determine the rotational speed,
the angle of rotation, or the direction of rotation by evaluating the impulse. The rotary encoders
from the ENI58PL product family allow the pulse count, the direction of rotation, and the output
type to be programmed via the standardized IO-Link interface. The programming is carried out
by integrating the device-specific IODD (IO Device Description) into an FDT frame program or
by using the Pepperl+Fuchs SmartBridge® and a mobile device in conjunction with the
SmartBridge® app via Bluetooth. We recommend using the "PACTware" software as an FDT
frame application.
5
Advertisement
Table of Contents
