Determining The Bootloader Version; Resetting The Devicemaster Air - Comtrol DeviceMaster AIR User Manual

Hide thumbs Also See for DeviceMaster AIR:

Table of Contents

Determining the Bootloader Version

50 - DeviceMaster AIR User Guide: 2000365 Rev. C

Use the following procedure to determine what bootloader version is loaded in the

DeviceMaster AIR.

1. Establish communications with the DeviceMaster AIR using the serial (Page

47) or telnet (Page 48) method.

2. At the RedBoot prompt, type version.

RedBoot> version

Comtrol DeviceMaster Boot Version 1.20

RedBoot(tm) debug environment - built 14:57:53, Jun 21 2004

Platform: Comtrol DeviceMaster (ARM 7TDMI)

RedBoot>

The bootloader information will display.

3. To update the bootloader on the DeviceMaster AIR, make sure that you

download the latest version and see

4. Type reset to reset the DeviceMaster AIR, if you do not have any other related

Redboot tasks.

When you have completed your tasks in Redboot, you must enter a reset command

at the RedBoot> prompt for the DeviceMaster AIR to begin operation.

Note: The LEDs on the DeviceMaster AIR will go through the power up sequence.

The unit has completed its reset cycle when the PWR or Status LED is lit

and it stops flashing.

Updating Firmware

on Page 39.

RedBoot Procedures

Table of Contents