Event Notification - Korenix JetPort 5201 User Manual

The Access IP Table specifies the IP address and subnet that can access to the device. The
access is based on IP and netmask combination.
If the access is open to all hosts, do NOT enable this function.

Event Notification

Specify the events that should be notified to the administrator. The events can be alarmed by
means of email, SNMP trap, or system log.
Device Notification:
Hardware Reset (Cold Start): Rebooting the JetPort will trigger the event
Software Reset (Warm Start): Restarting the computer will trigger the event
Login Failed: Using wrong password in console will trigger the event
IP Changed: Changing network setting will trigger the event
Password Changed: Changing the password will trigger the event
Access IP Blocked: Report blocked IP addresses
Port Notification:
DCD changed: When DCD (Data Carrier Detect) signal changes, indicating the
modem connection status has changed, the event will be triggered.
RI changed: When RI (Ring Indicator) signal changes, indicating the incoming of a call,
the event will be triggered.
DSR changed: When DSR (Data Set Ready) signal changes, indicating that the data
communication equipment is powered off, the event will be triggered.
CTS changed: When CTS (Clear To Send) signal changes, indicating that the
transmission between computer and DCE can proceed.
Port connected: In TCP Server Mode, when the device accepts an incoming TCP
connection, this event will be trigger. In
connected to the remote host, this event will be trigger. In Virtual COM Mode, when
Virtual COM is ready to use, this event will be trigger.
Port disconnected: In TCP Server/Client Mode, when the device lost the TCP link, this
event will be trigger. In Virtual COM Mode, When Virtual COM is not available, this
event will be trigger.
JetPort Serial Device Server User's Manual
Web and Telnet Console
TCP Client Mode, when the device has
4-7