Table of Contents
Advertisement
The General section lists information of "Model", "Firmware Version", "IP Address", and "MAC
Address".
You can modify Device Name and remark Location information.
Using SNTP Time Server: Enable Time Server by specifying SNTP server IP and Port.
Auto IP Report: If this device uses DHCP or BootP IP, enable Auto IP Report will report its
dynamic IP address to the specified host regularly. You can use "Get Current Host" to assign the
IP report to be sent to current host. Specify "Report Interval" as to how often the IP address
should be sent, zero means no report will be sent.
After modifying configuration, be sure to validate the changes by using "Apply Only" or "Apply
and Save".
Locate the Device
JetPort Commander can identify one device among the others by the IP address with the "Locate
On" function in General Menu. Select the "Locate On"
LED will blink Green continuously until you select the "Locate Off"
Security
JetPort Security includes access list and administration security.
Access List
The Access IP Table specifies the IP address and subnet that can access to the device. The
access is based on IP and netmask combination.
If the access is open to all hosts, do NOT enable this function.
Administration Security
JetPort Serial Device Server User's Manual
Windows Management Tool
Product Tip: Always save your configurations to validate
the changes with 2 options.
Apply Only: Only apply the change one time without saving.
When rebooting the device, the changes will not exist.
Apply and Save: The change will be applied and save in
Flash. When rebooting the device, the changes are still
alid
function and the PWR/Ready
function.
3-3
Advertisement
Table of Contents
