Notification - Korenix JetPort 5201 User Manual

Notification

Port status can be notified to administrator by means of Email, SNMP trap, or System Log.
The events for notification include:
DCD changed: When DCD (Data Carrier Detect) signal changes, indicating the
modem connection status has changed, the event will be triggered.
RI changed: When RI (Ring Indicator) signal changes, indicating the incoming of a call,
the event will be triggered.
DSR changed: When DSR (Data Set Ready) signal changes, indicating that the data
communication equipment is powered off, the event will be triggered.
CTS changed: When CTS (Clear To Send) signal changes, indicating that the
transmission between computer and DCE can proceed.
Port connected: In TCP Server Mode, when the device accepts an incoming TCP
connection, this event will be trigger. In
connected to the remote host, this event will be trigger. In Virtual COM Mode, when
Virtual COM is ready to use, this event will be trigger.
Port disconnected: In TCP Server/Client Mode, when the device lost the TCP link, this
event will be trigger. In Virtual COM Mode, When Virtual COM is not available, this
event will be trigger.
To enable activate the notification, specify the event type and the notification methods.
The details of SNMP trap Server, Email SMTP server, or Log server IP should be configured first
properly in device "Configuration" "Management".
3-16
JetPort Serial Device Server User's Manual
TCP Client Mode, when the device has