Lawn-Boy M Series Service Manual page 98

63
Install engine wiring harness through hole
in crankcase and secure into wire tie. Attach
wire connectors. Refer to Section 5 wiring dia-
gram for specific model connections.
64
Electric Start Models:
Install alternator assembly. Refer to Section
5 for Air Gap Adjustment Procedure.
Connect Red lead from alternator to Green lead
in wiring harness.
Install shroud and secure to head and
crankcase rear tab with three screws. Install
shoulder bolt through air filter base.
NOTE: Check that wiring harness is above
tab of shroud near crankcase and that spark
plug lead is in position along side of cylinder
head.
Torque mountlng screws to 65 in.-lbs.
(5 ft.-lbs.) (7 N.M)
7-22