Installation - Lawn-Boy M Series Service Manual

7
Examine brake pad for excessive wear.
SPECIFICATION
Replace brake and switch assembly if pad
is less than 1/32
inch
thick.
Check wire terminals for damage. Check brake
spring for distortion or damage.
INSTALLATION
8
Assemble brake and switch assembly to
brake actuator lever. Secure with shoulder bolt
and lock nut.
Torque shoulder bolt to 75 in.-lbs.
(6 ft.-lbs.) (8 N.M)
9
Attach wire (s) to terminals on brake and
switch assembly
as
shown.
NOTE: Ignition (yellow) wire on lower or
single terminal Electric Start Models: Connect
blue wire to upper terminal.
NOTE: The service replacement brake and
switch assembly may have two terminals. On
zone start models the upper contact is not used.
Brake and Switch Assembly Brake Pad
-1/32"
minimum
Brake and Switch
Actuator
Lever
Brake and Switch Assembly
Blue (Electric Start Models Only)
9