Stuart Turner Mainsboost Flomate MBF 12 Installation & Maintenance Instructions Manual page 4

This appliance must be earthed via the supply cord,
z
which must be correctly connected to the earth
point located in the terminal box.
The supply cord and internal wiring within the
z
terminal box are routed and secured to ensure
compliance with the electrical standard
EN 60335-1. It is essential that prior to any
disturbance of this internal wiring, all cable routing
and securing details are carefully noted to ensure
re-assembly to the same factory pattern is always
maintained.
If the supply cord is to be changed or is damaged, it
z
must be replaced with a special cord assembly
available from Stuart Turner or one of their approved
repairers.
Notes
This product must be installed in accordance with the
z
current Water Supply (Water Fittings) Regulations.
Under no account should the internal flow restrictor
z
be removed, or replaced with an alternative design.
Care must be taken to ensure the maximum pressure
z
generated by the pump combined with the incoming
mains water pressure does not exceed the pumps
maximum operating pressure of 6 bar.
Please read installation details carefully as they are intended to ensure this product
provides long, trouble free service. Failure to install the unit in accordance with the
installation instructions will lead to invalidation of the warranty.
- 4 -