ProFire PF2200-SB Installation Manual page 5
Hide thumbs
Also See for PF2200-SB:
- Product manual (98 pages) ,
- Installation manual (34 pages) ,
- User manual (21 pages)
Advertisement
SAFETY INFORMATION
Before installing the PF2200 system, please review the list of warnings below. Product use in a manner not
specified by PROFIRE is not recommended. Failure to observe the following warnings may result in death,
electrocution, property damage, product damage, government fines, or malfunction of the product itself.
GENERAL WARNINGS
•
Installation and product use must conform to the directions in this manual.
•
Solenoid powered outputs are rated to 5A max individually; however, the power input to the BMS
card is fused at 10A. Care must be taken not to exceed the 10A max input when installing with high-
powered solenoids.
•
Do not jumper solenoid (-) terminals together under any circumstance; this compromises the safety-
integrity of the system.
•
Safety Functions must be end-to-end proven during commissioning (e.g., when using a high pressure
switch, ensure a high-pressure event triggers a lock-out).
INSTALLATION WARNINGS
•
Electrical devices connected to the controller must meet local electrical codes and be within voltage
limits specified in this manual.
•
Ensure the enclosure is securely closed each time after opening. Improper closure may result in
moisture and or other environmental damage and may also compromise the integrity, and warranty
of the product.
•
The System must be connected appropriately to earth-ground to prevent electrocution.
•
No more than one conductor is to be used per contact point.
•
Properly fuse field wiring to local codes.
•
Do not disassemble or modify the cards in any way. The cards are not field repairable and must be
sent back to Profire for a replacement if damaged.
•
Card installation shall be performed in accordance with local electrical code(s) by a capable
electrician. Installation and modification shall NOT be performed while the system is energized.
•
Failure to provide a low-impedance path from the burner assembly to the PF2200 may result in
accidental electric shock, product damage, failure to ignite the pilot or failure to detect a flame.
•
Do not connect wires or handle the electronics when powered.
•
Do not modify the product once installed.
•
Bypass of safety function(s) is required to update software.
DOC-001041 / v1.0
5
Advertisement
