Protocol - Memmert UN PLUS Series Operating Instructions Manual

Menu functions

7.8 Protocol

The appliance continually logs all relevant measured values, settings and error messages at
1-minute intervals. The internal log memory is of the continuous memory type. The logging
function cannot be switched off and is always active. The measured data are stored in the
appliance, safe from manipulation. If the power supply is interrupted, the time of the power
failure and voltage recovery are stored in the appliance.
You can export the protocol data for different periods to a USB storage medium via the
USB interface or, via Ethernet, import them to the AtmoCONTROL software for graphical
representation, print-out or storage.
The log memory of the appliance is not modified or deleted by reading it out.
1. Connect the USB storage medium to the
interface on the right side of the control
panel.
2. Activate the protocol. To do so, press
the activation key on the right side of
PROTOCOL
the
is enlarged and the period
automatically highlighted. To select
another logging period, use the turn
control.
3. Save your selection by pressing the
confirmation key. The transfer starts and
a status symbol indicates the progress.
If no USB storage medium has been
connected or the medium connected is
full, a warning will be issued.
4. As soon as the transfer is complete, a
check mark appears in front of the period
selected. You can now remove the USB
storage medium.
For a description of how to import and process protocol data in AtmoCONTROL or
read them out via Ethernet, please observe the separate AtmoCONTROL manual.
50
display. The display
1 week
PROTOCOL
control range
12.10.2012 12:00
1 week
1 month
Complete control range
1 week
1 month
Complete control range