Timer Operation - Memmert UN PLUS Series Operating Instructions Manual

Hide thumbs Also See for UN PLUS Series:
Table of Contents

Advertisement

Operation and control

5.4.5 Timer operation

In timer operation, you can adjust the time the appliance runs at the set value:
1. Press the activation key to the left of
the timer display. The timer display is
activated.
2. Turn the turn control until the desired
duration is displayed – in this example 4
hours 30 minutes. The approximate end
time is shown beneath, in a smaller font.
Up to a duration of 23 hours 59 minutes, the time is displayed in hh:mm (hours:minutes)
format. For 24 hours and more, the format dd:hh (days:hours) is used. The maximum
duration adjustable is 99 days 23 hours.
3. Press the confirmation key to confirm.
The display now shows the remaining
time in a large font and the approximate
end time in a smaller font beneath.
4. Now, as described under 5.4.2 , set the individual values for temperature, air flap position
etc. which you want the appliance to operate at. For universal ovens UN
incubators IN
PLUS
are effective immediately. For sterilisers SN
the timer elapses.
For universal ovens UN
should run setpoint-dependent or not in the
not start until a tolerance band around the set temperature is reached or if it should start
right after activation (see page 42). If the timer runs setpoint-dependent, this is indicated by
the
symbol in the timer display.
When the timer has elapsed, the display shows 00:00. All functions
(heating etc.) are switched off. If a fan had been active, it will keep
on running for a short safety period.
To deactivate the timer, open the timer display by pressing the
activation key again and then turning the turn control to reduce
the timer setting until --:-- is displayed. Confirm with the confirma-
tion key.
26
/IF
, the set values can be changed while the timer elapses. The changes
PLUS
/UF
and incubators IN
PLUS
PLUS
/SF
, parameters cannot be changed while
PLUS
PLUS
/IF
, you can choose if the timer
PLUS
PLUS
Setup
– this determines if the timer should
FA
TIMER
0
0
00
h
m
Ende 23.11. 09:00
TIMER
04
3
0
h
m
23.Nov 13:30
End
TIMER
04
30
h
m
End
23.Nov 13:30
/UF
and
PLUS
PLUS
TIMER
00
00
h
m
End
23.Nov 13:30
TIMER
--
--
h
m
End
23.Nov 13:30

Advertisement

Table of Contents
loading

Table of Contents