Table of Contents
Advertisement
2-38
Coral IPx 800 Installation Manual
Common Control Card Installation
Refer to
for common control card placement in the Coral IPx 800M cage.
Figure 2-19
1.
Verify that the IMC8/IMC16 Flash Memory card is properly installed in its
connector on the front side of the MEX-IP2 card.
2.
Install the SAU plug on its corresponding connector on the front side of the
MEX-IP2 card.
3.
Verify that the MEX-IP2 common control card is partially inserted into the card
slot on the extreme right slot of the main cage. The cage is normally shipped with
this card inserted in its card slot. Partially extract it from its card slot, such that the
cards protrudes from the cage by approximately 1 inch (2.5 cm).
4.
Verify that the HDC card is partially inserted into the second right slot of the main
cage. The cage is normally shipped with this card inserted in its card slot. Partially
extract it from its card slot, such that the cards protrudes from the cage by
approximately 1 inch (2.5 cm).
5.
Insert the PX card into slot 1 of the first expansion cage such that the card
protrudes from the cage by approximately 1 inch (2.5cm).
Advertisement
Table of Contents
Troubleshooting
