Tadiran Telecom Coral IPx 800 Series Installation Procedure And Hardware Reference Manual page 5

Federal Communications Commission
Rules Part 68 Compliance Statement
This equipment complies with Part 68 of the FCC rules. On this equipment is a label that contains,
among other information, the FCC registration number and ringer equivalence number (REN) for this
equipment. If requested, this information must be provided to the telephone company.
The REN is used to determine the quantity of devices which may be connected to the telephone line.
Excessive REN's on the telephone line may result in the devices not ringing in response to an incoming
call. In most, but not all areas, the sum of the REN's should not exceed five (5.0). To be certain of the
number of devices that may be connected to the line, as determined by the total REN's contact the
telephone company to determine the maximum REN for the calling area.
An FCC compliant telephone cord and modular plug is provided with this equipment. This equipment is
designed to be connected to the telephone network or premises wiring using a compatible modular jack
which is Part 68 compliant.
This equipment cannot be used on telephone company-provided coin service. Connection to Party Line
Service is subject to state tariffs.
If this equipment causes harm to the telephone network, the telephone company will notify you in
advance that temporary discontinuance of service may be required. If advance notice is not practical, the
telephone company will notify the customer as soon as possible. Also, you will be advised of your right
to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations, or procedures that
could affect the operation of the equipment. If this happens, the telephone company will provide
advance notice in order for you to make the necessary modifications in order to maintain uninterrupted
service.
If trouble is experienced with this equipment, please contact the supplier at (516)-632-7200 for repair
and/or warranty information. If the trouble is causing harm to the telephone network, the telephone
company may request you remove the equipment from the network until the problem is resolved.
The following repairs can be done by the customer: No repairs allowed.
This equipment is hearing-aid compatible.
It is recommended that the customer install an AC surge arrestor in the AC outlet to which this device is
connected. This is to avoid damaging the equipment caused by local lightning strikes and other electrical
surges.
This equipment is capable of providing user's access to interstate providers of operator services through
the use of equal access codes. Modifications by aggregators to alter these capabilities may be a violation
of the telephone operator consumer services improvement act of 1990 and part 68 of the FCC Rules.
i