Table of Contents
Advertisement
8.
Secure the power supply to the card cage by fastening the two M4x10 screws,
located at the top and bottom of the unit's front panel to the cage, thus securing
the card to the cage as well as grounding the unit.
9.
Turn the PS19 DC power switch ON, and verify that the green Power indicator is
lit, while the red Alarm indicator is not lit.
Turn ON the PS19 DC units in the expansion cages only after powering the main cage
(IPx 800M) and verifying that the main cage has initialized properly and the alarm
indicator does not illuminate. Otherwise the cards in the expansion cages (IPx 800X)
might not initialize.
Removing the Power Supply
1.
Locate a desk or table top that can support 50lb (23kg). If the surface can be
damaged by sharp objects, place a protective sheet of cardboard or similar
material over the top surface.
2.
Place an anti-static sheet (the card's plastic shipping bag will suffice) over a desk
or a table top.
3.
Turn the PS19 DC power switch OFF (turn the switch downwards).
Do not remove the power supply unit from the cage when turned ON. Sudden power
surges could damage system components. Before extracting the PS19 DC card, verify
that the power switch is turned OFF.
4.
Unfasten the two M4x10 screws located at the top and bottom of the unit's front
panel and set aside.
5.
Carefully remove the PS19 DC from its slot.
6.
Place the PS19 DC over the anti-static material with the component side facing
upwards.
7-11
Power Supplies
Advertisement
Table of Contents
Troubleshooting
