Table of Contents
Advertisement
5.
Secure the PS19 AC to the card cage by fastening the two captive screws, located
at the top and bottom of the PS19 AC to the cage. See
6.
Turn the power switch ON, and verify that the green Power indicator is lit, while
the red Alarm indicator is not lit.
Turn ON the PS19 AC units in the expansion cages only after powering the Main Cage
(IPx 800M) and verifying that the Main Cage has initialized properly and the alarm
indicator does not illuminate. Otherwise the cards in the expansion cages (IPx 800X)
may not initialize.
Removing the Power Supply
1.
Locate a desk or table top that can support 50 lb (23kg). If the surface can be
damaged by sharp objects, place a protective sheet of cardboard or similar
material over the top surface.
2.
Place an anti-static sheet over a desk or a table top (the card's plastic shipping bag
will suffice).
3.
Turn the PS19 AC power supply switch OFF (turn the switch downwards).
Do not remove the PS19 AC unit from the cage when turned ON. Sudden power surges
could damage system components. Before extracting the PS19 AC card, verify that the
power switch is turned OFF.
4.
Unfasten the two captive screws on the front panel of the PS19 AC. See
7-10.
5.
Carefully remove the PS19 AC from its slot.
6.
Place the PS19 AC over the anti-static material with the component side facing
upwards.
Figure
7-10.
Figure
7-47
Power Supplies
Advertisement
Table of Contents
Troubleshooting
