2-34
Coral IPx 800 Installation Manual
3.
Verify that the PS19 power switch is turned OFF (downwards). See
Do not insert or remove the power supply unit from the cage when turned ON.
Sudden power surges could damage system components.
4.
Grasp the power supply with both hands, with your fingers on the top and
bottom of the power supply near the front panel, and thumbs against the extractor
levers at the top and bottom of the front panel.
5.
Align the two guide ridges located on the right panel of the power supply (top
and bottom) with the card edge guides corresponding to the POWER SUPPLY
marking at the bottom of the card cage and gently slide the power supply straight
into the card slot.
6.
Remove the power supply units from their shipping cartons and partially insert
them into the card slots as determined above. Allow the units to protrude from
the card cage by approximately 1 inch (2.5cm).
Figure
2-18..