Installation Of Chain Tray; Installation Of Warning Signs - DoorKing 9500 Series Installation & Owner's Manual

1.5 Installation of Chain Tray

A chain tray is recommended for longer gates to support the weight of the chain. DoorKing offers a chain tray and supporting
brackets in sections to fit any length gate. (DoorKing P/N 2601-270 10 Ft. section)

1.6 Installation of Warning Signs

This DoorKing Slide Gate Operator is shipped with two warning signs. The
purpose of the warning sign is to alert uninformed persons, and to remind
persons familiar with the gate system, that a possible hazard exists so that
appropriate action can be taken to avoid the hazard or to reduce exposure to
the hazard. See page 3 for typical placement of signs.
• Permanently install the supplied warning signs in locations so
that the signs are visible by persons on both sides of the gate.
• Use appropriate hardware such as wood or sheet metal screws
(not supplied) to install the warning signs.
12
Carriage Bolts
Chain Tray Segment Connection
All gate types can have the chain tray
installed on them, V-rail v-wheel
ornamental is shown here. For further
information, refer to instructions
provided with the chain tray kit.
Supporting
Bracket
Note: The chain should sag at least
one (1) inch per 10 feet of travel.
Weep Hole
View A
WARNING
MOVING GATE CAN CAUSE
SERIOUS INJURY OR DEATH
Operate gate only when gate area is in sight
and free of people and obstructions.
Do not allow children to play in gate area
or operate gate.
Do not stand in gate path or walk through
path while gate is moving.
Read owner's manual and safety instructions.
Chain Tray
Supporting
Bracket
11"
9510-065-D-5-20