Section 6 - Operating Instructions; Built-In Controls And Reset Button Description - DoorKing 9500 Series Installation & Owner's Manual

This vehicular gate operator is designed for Class III and Class IV applications only. All users of this gate operating
system MUST be trained on the proper and safe operation of the system and must made aware of all hazards that
may be associated with the system.
WARNING - To reduce the risk of injury or death:
1. READ AND FOLLOW ALL INSTRUCTIONS.
2. Never let children operate or play with gate controls. Keep the remote control away from children.
3. Always keep people and objects away from gate. NO ONE SHOULD CROSS THE PATH OF THE MOVING GATE.
4. Test the operator monthly. The gate MUST reverse on contact with a rigid object or stop or reverse when an object
activates the non-contact sensors. After adjusting the force or the limit of travel, retest the gate operator. Failure to
adjust and retest the gate operator properly can increase the risk of injury or death.
5. Use the emergency release only when the gate is not moving and power has been shut-off.
6. KEEP GATES PROPERLY MAINTAINED. Read the owner's manual. Have a qualified service person make repairs to gate
hardware.
7. The entrance is for vehicles only. Pedestrians must use separate entrance.
8. SAVE THESE INSTRUCTIONS.

6.1 Built-In Controls and Reset Button Description

Unlock (If padlocked) and remove the
polypropylene cover (See section 1.1
Removing cover on page 8) to gain
access to these controls OR unlock
and remove door of optional steel
cover (see below).
AC Power Switch
operator ON or OFF.
Do not change any adjustments
Push to Operate Button
cycle the operator. It will use the
auto close timer if turned on to
Opens gate fully.
3-Push Button
close or stop gate. Does NOT use
the auto close timer. Overrides
other opening devices.
Opens gate fully.
ON
OFF
E
OPE RAT only
TO H use
techn PUS ician
EN
OP
SE
CLO
P
STO
n a l
t i o
r
O p o v e
e l C
S t e
9510-065-D-5-20

SECTION 6 - OPERATING INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS
- Powers the
25 A
23
20
TE ST
- Used to
close the gate.
- Used to open,
E
A T
E R
O P ly
o n
T O
s e
S H n u
P U ic ia
h n
te c
E N
O P
E
O S
C L
O P
S T
Reset Button
turn off the entrapment
alarm and to reset the
operator after a HARD
shutdown has occurred.
Accessible without
removing the cover.
WARNING
MOVING GATE CAN CAUSE
SERIOUS INJURY OR DEATH
Operate gate only when gate area is in sight
and free of people and obstructions.
Do not allow children to play in gate area
or operate gate.
Do not stand in gate path or walk through
path while gate is moving.
Read owner's manual and safety instructions.
- Used to
Alarm Siren
29