6.3 Manual Gate Operation
Caution:
Never attempt to manually operate any gate until you have verified that power to the operator has been shut-off.
1
Remove the Cover
Inside
Cover
Steel cover has same removal
Catch
procedure as polypropylene cover.
Chassis
Cover
Catch
1.
Lift cover on padlock bracket end a few inches.
2.
Slide cover horizontal to free cover from chassis cover catch.
3.
Lift cover off vertical.
BE CAREFUL not to hit internal components with cover!
CAUTION
Eye-Bolts Are For Lifting Cover ONLY. Be Sure
Cover Is Disconnected From Operator Frame
Before Attempting To Lift.
Attempting To Lift Operator from These Eye-
BoltsMay Result In Minor To Moderate
Personnel Injury And Will Result In Damage To
The Cover And Operator.
Optional steel cover Caution
10:1 Gearbox ONLY
Manual Release-
Back-driveable
Power MUST be shut-off. Gate can be
backdriven without using manual crank
tool. See specifications page in front of
this manual for specific 9500 models.
9510-065-D-5-20
3
Polypropylene
Cover shown here
2
Idler Wheels
1
Padlock
Bracket
Padlock
Not Provided
Padlock
Bracket
Insert the supplied manual hand crank into the motor
shaft underneath the interlock door. Turn the crank to
open the gate.
Magnetic disc brake will automatically
disengage when power is shut-off and
reengage after power has been restored.
Magnetic
Disc Brake
2
Manually
Crank
- Cuts off AC
Interlock
power to the operator.
31