Section 1 - Installation; Removing Cover; Underground Conduit Requirements - DoorKing 9500 Series Installation & Owner's Manual

Prior to beginning the installation of the slide gate operator, we suggest that you become familiar with the instruc-
tions, illustrations, and wiring guide-lines in this manual. This will help insure that your installation is performed in
an efficient and professional manner compliant with UL 325 safety and ASTM F2200 construction standards.
The proper installation of the vehicular slide gate operator is an extremely important and integral part of the
overall access control system. Check all local building ordinances and building codes prior to installing this
operator. Be sure your installation is in compliance with local codes.
3
2
1
Optional Steel Cover
Padlock
Not Provided
Padlock Bracket
CAUTION - Eye-bolts are for lifting the cover ONLY. Be sure the cover is disconnected from the
operator before attempting to lift. Attempting to lift the entire operator from these eye-bolts WILL
result in damage to the cover and operator and may result in a minor or moderate injury to personnel.

1.2 Underground Conduit Requirements

• The conduit requirements are for a typical slide gate operator installation. The conduit requirements for your application
may vary from this depending on your specific needs.
• Use only sweeps for conduit bends. Do not use 90° elbows as this will make wire pulls very
difficult and can cause damage to wire insulation. DoorKing recommends using 3/4-inch conduit.
• External Entrapment Protection is REQUIRED (photo sensors and/or reversing edges).
• Be sure that all conduits are installed in accordance with local codes.
• Never run low voltage rated wire insulation in the same conduit as high voltage rated wire insulation.
8

SECTION 1 - INSTALLATION

1.1 Remove Cover
Eye-Bolts
1.
Lift cover on padlock bracket
end a few inches.
2. Slide cover horizontal to free
cover from chassis cover catch.
3. Lift cover off vertical.
BE CAREFUL not to hit internal
components with cover!
Note: The owner of the
gate operator is
responsible for the
Chassis
PADLOCK KEY or STEEL
Cover
COVER KEY availability.
Catch
Operator
Position
External Safety Devices, Control Wires (Low Voltage wire insulation)
Loop Lead-In Wires (Low Voltage wire insulation)
AC Input Power (High Voltage wire insulation)
Sweeps
3/4 Inch Minimum
Polypropylene
Cover
Inside
Cover
Catch
Idler Wheels
Chassis
Cover
Catch
3
2
1
Padlock Bracket
Padlock
Not Provided
Padlock Bracket
Sweep
YES
Elbow
NO
9510-065-D-5-20