Section 8 - Owner Of The Gate Operator; Alarm Sounding And Gate Will Not Operate - DoorKing 9500 Series Installation & Owner's Manual

SECTION 8 - OWNER OF THE GATE OPERATOR

8.1 Alarm Sounding and Gate WILL NOT Operate

When alarm is sounding . .
Note: Owner of the gate operator is
responsible for safe gate operation
and must be aware of all safety
requirements in this manual.
Gate Operator is in a Hard Shutdown Condition when Alarm is Sounding
This occurs when:
1. The inherent entrapment protection system (Type A) gets activated TWO consecutive times before the gate completes
the open or close cycle.
2. The reversing edge contact sensor (Type B2) gets activated and reverses but before the gate completes the reverse
cycle the inherent entrapment protection system (Type A) gets activated.
The audio alarm will sound for five minutes, or until the operator's reset button is pushed. After (5) five minutes the
alarm will "chirp every 5 sec." and the hard shutdown condition will remain in affect until the reset button is pushed.
Please read SECTION 6 - OPERATING INSTRUCTIONS for more information about operating this gate operator.
36
ALWAYS CHECK GATE AREA FOR ANY OBSTRUCTIONS FIRST.
WARNING
MOVING GATE CAN CAUSE
SERIOUS INJURY OR DEATH
Operate gate only when gate area is in sight
and free of people and obstructions.
Do not allow children to play in gate area
or operate gate.
Do not stand in gate path or walk through
path while gate is moving.
Read owner's manual and safety instructions.
RESET
BUTTON
If the cause of the alarm cannot be corrected,
shut-off power and DO NOT place this operator
back into service until the malfunction can be
identified and CORRECTED.
IMPORTANT: Putting this gate operator
back into service without CORRECTING
the cause of the alarm could result in
serious injury or DEATH!
Press RESET BUTTON.
This will reset the gate
operator and allow normal
gate operation again.
Accessible without
removing the cover.
9510-065-D-5-20