H.C Duke & Son Electro Freeze GENESIS Series Operator’s Manual With Illustrated Parts List page 38

ELECTRO FREEZE Soft Serve Model GEN-5099
8 Assembly
Figure 8-4 Head Assembly
then lubricate the O-rings (2) on the
plungers (4&8) and insert plunger halfway
into dispensing head (1).
4-inch head O-rings (3).
plungers (4&8) and dispensing head (1).
Lock in place with the handle pin (9).
the air bleed plug (6). Insert plug in the
dispensing head (1) assembly.
surface of the cylinder bushing and place
on the end of the beater shaft.
ALWAYS make sure the cylinder
bushing is positioned on the beater
shaft properly. Operating the freezer
with a missing or badly worn bushing
will damage the beater and cylinder.
28
(continued)
5. (Refer to figure 8-4.) Install and
6. Install and then lubricate the
7. Position the handle (10&12) in the
8. Install and lubricate O-rings (5) on
9. Lubricate the inside bearing
Important:

Important:

Excessive force will damage the head.
Do not use tools to tighten.
10. Install the dispensing head onto
the freezer by aligning the studs with the
holes in the head and sliding toward the
freezer. Evenly tighten the hand knobs,
finger tight only. Repeat for second head
assembly.
11. Install the plunger rods (7). The
nozzle (13) will be installed on the mix
outlet at the bottom of the head after
sanitizing.
– continued
185242