H.C Duke & Son Electro Freeze GENESIS Series Operator’s Manual With Illustrated Parts List page 23

ELECTRO FREEZE Soft Serve Model GEN-5099
4 Part Names and Functions
The following descriptions apply to figure 4-3. The number preceding the part name
corresponds to the number in the figure.
1.) SUPPORT - ROLLER BEARING:
Holds roller assembly in place.
2.) SHOE - ROLLER: Provides an
opening to insert the mix transfer
hose. Squeezes transfer hose
against rollers.
3.) ROLLER ASSEMBLY COMPLETE:
Squeezes mix/air through tubing to
freezing cylinder.
4.) KNOB - HAND: Locks roller shoe in
position.
5.) ARM - SWING CLAMP: Swings
hand knob into position over roller
shoe.
6.) RETAINER - AIR TUBE: Holds air
meter tube in the "up" position.
7.) AIR METER: Regulates the amount
of air being drawn into the system.
8.) TUBE - AIR: Provides connection
for the air meter.
9.) CLAMP - ASSY. SOFT HOSE 5/8":
Prevents mating parts from leaking.
10.) HOSE - ASSY. MIX BRAIDED:
Connecting tube between the Mix
Transfer System and the cylinder
inlet.
11.) COVER - MTS: Protection against
moving parts. Cover must be in
place for the MTS to operate.
12.) HOSE - TRANSFER RED: Special
"red-lined" hose that is squeezed by
rollers to transfer mix to freezer.
13.) TUBE - ASSEMBLY MIX INLET:
Carries mix from mix container to
MTS.
185242
(continued)
14.) DUCKBILL: A rubber check valve
that prevents mix from falling back
into the mix container.
15.) PORT - AIR/MIX: Blends air and mix
as it flows into the transfer hose.
16.) CLIP - TUBE RETAINER: Locks mix
pickup tube into air/mix port.
17.) O-RING - MIX TUBE: Seals the mix
tube in the air/mix port.
18.) SHOE - SPRING: Holds clamp in
place.
13