H.C Duke & Son Electro Freeze GENESIS Series Operator’s Manual With Illustrated Parts List page 35

ELECTRO FREEZE Soft Serve Model GEN-5099
7.3 Cleaning Instructions
scraper blade pin holes as shown in figure
7-8.
Do not leave parts in sanitizer for more
than 15 minutes.
3. After all parts are washed, rinse
and then place them in the sanitizing
solution. Brush the inside of all mix
transfer hoses with sanitizer. For proper
sanitizing, the parts must remain fully
immersed in the sanitizer for 5 minutes.
Allow parts to air-dry after sanitizing.
4. Using a warm dish detergent
solution thoroughly brush; the mix feed
tubes from the refrigerated cabinet to
the cylinders as shown in figure 6-9, the
inside of the cylinders including the back
wall, and the inside of the drain tube, as
shown in figure 7-10.
5. Remove the drip tray and insert.
Wash in a warm dish detergent solution
and rinse with clear water.
6. Wash the outside of the freezer
and inside of the cabinet with a warm dish
detergent solution. Rinse with clear water.
185242
e. The beater shafts and the
Important:

Replace worn
brushes.
Use only Electro
Freeze original
or authorized
replacement parts.
See Accessories
parts list in Part II of
this Manual to order
new brushes.
(continued)
Figure 7-8
holes.
Figure 7-9
Figure 7-10 Brush inside of drain
tube.
Clean beater shaft pin
Brush inside of cylinder mix
feed tubes.
25