H.C Duke & Son Electro Freeze GENESIS Series Operator’s Manual With Illustrated Parts List page 49

ELECTRO FREEZE Soft Serve Model GEN-5099
12 Routine Maintenance
AS NEEDED
swing clamp and open shoe to gain
access to the hose cavity.
hose assembly.
cabinet base below the MTS.
supplied, flush the hose cavity and
roller assembly.
to clean in between rollers. Flush
with sanitizer.
clean dry cloth.
shoe. See figure 11-1.
SHOE SWING CLAMP
O-RING
WASHER
KNOB
Figure 11-1
185242
(continued)
CAUTION
Make sure the freezer
is depressurized before
proceeding.
a. Remove cover, loosen
b. Remove mix transfer
c. Lay a towel on the
d. Using the spray bottle
e. Use a brush (supplied)
f. Wipe all surfaces with a
g. Remove and clean
RIGHT SIDE SHOWN
LEFT SIDE THE SAME EXCEPT MIRRORED
LUBRICATE WITH FOOD
GRADE LUBRICANT
SWING CLAMP ARM
ROLLER SHOE
O-RING
PRESSURE RELIEF SPRING
(continued)
for wear, including seals, O-rings,
mix transfer tubes, and blades.
Replace blades if worn 3/16" or more.
drive coupling for wear.
A worn coupling will have a nonparallel
shape on the drive opening.
BRUSH BETWEEN ROLLERS
LUBRICATE WITH FOOD
GRADE LUBRICANT
SHOE PIVOT ARM
M02082
WEEKLY
1. Carefully inspect all parts
2. Replace as required.
3. Check the shaft tang and
39