Single Wheels; Walking Beams - Landoll 1230 Series Operator's Manual

Figure 3-6 - Wheel Spindle and Adapter

3-6 SINGLE WHEELS

3-6.1 Slide tube adapter (2-1/4" dia. x 7-1/2"
long) over hub spindle (See Figure 3-6).
3-6.2 Align inner hole in adapter with hole in
spindle and install 3/8" x 2" roll pin.

3-7 WALKING BEAMS

3-7.1 Insert wheel spindles into walking beam .
Align holes and install 3/8" x 2-1/2" roll pin,
one in each wheel spindle (See Figure 3-8).
Figure 3-8 - Walking Beam and Hubs
3-6
Figure 3-7 - Single Wheel Installation
3-6.3 Insert spindle and adapter into lift arm,
align holes and install 3/8" x 3-1/2" cap
screw, locknut (See Figure 3-7).
3-6.4 Attach wheels to hubs with wheel bolts
shipped in hubs. Tighten to 80 ft-lb (108
N×m).
Note: Use hole "A" for normal tire clearance or
hole "B" for additional clearance.
3-7.2 Insert walking beam into rockshaft lift arm
with beam toward outside of frame. Align
holes and install 3/8" x 3-1/2" cap screw,
locknut (See Figure 3-9).
3-7.3 Attach wheels to hubs with wheel bolts
shipped in hubs. Tighten to 80 ft-lb (108
N×m).
Figure 3-9 - Attaching Walking Beam