Installing The Display Panel - Dell Latitude 5411 Service Manual

2. Remove the two (M2.5x3) screws that secure the display panel to the display assembly.
3. Lift to turn over the display panel to access the display cable.
4. Peel the conductive tape on the display cable connector.
NOTE: Do not pull and release the Stretch (SR) tapes from the display panel. There is no need to separate the
brackets from the display panel.
5. Lift the latch and disconnect the display cable from the connector on the display panel.

Installing the display panel

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the display panel and provides a visual representation of the installation procedure.
70 Disassembly and reassembly