Power Button; Installing The Power Button With Fingerprint Reader - Dell Latitude 5411 Service Manual

Next steps
1. Install the DC-in.
2. Install the heatsink-UMA.
3. Install the LED board.
4. Install the inner frame.
5. Install the memory.
6. Install the WLAN card.
7. Install the WWAN card.
8. Install the 2280 SATA SSD.
9. Install the battery.
10. Install the base cover.
11. Follow the procedure in

Power button

Installing the power button with fingerprint reader

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the power button with fingerprint and provides a visual representation of the installation procedure.
Steps
1. Locate the power button with fingerprint slot on your computer.
2. Align and place the power button with fingerprint into the slot on your computer.
3. Install the two (M2x2) screws that secure the power button to the palmrest.
Next steps
1. Install the system board.
NOTE: System board can be installed with heatsink attached.
After working inside your computer.
Disassembly and reassembly 59