Generator Trip Levels - BOMBARDIER Challenger 601-3A CL-600-2B16 Pilot Training Manual

Hide thumbs Also See for Challenger 601-3A CL-600-2B16:
Table of Contents

Advertisement

The CSD oil also acts as a cooling agent for
the CSD and the generator. The oil is cooled
in a heat exchanger located on the engine
pylon service assembly. A sight glass on the
CSD allows for oil quantity checking. An oil
filter with a pop-out indicator button is pro-
vided to signal the need for a filter change. A
magnetic chip detection device is incorpo-
rated into the CSD drain plug.
GENERATOR
CONSTANT SPEED
DRIVE (CSD)
Figure 2-2. Integrated-Drive Generator
Generator
The AC generator is a 30-kilovolt-amp (kva),
115-/200-volt, 3-phase, 400-Hz, brushless al-
ternator that is lubricated, cooled, and driven
by the CSD.
PARAMETER
Voltage
Frequency
Power
CL-600-2B16 PILOT TRAINING MANUAL
ENGINE
ACCESSORY
GEARBOX
Table 2-1. GENERATOR TRIP LEVELS
TRIP LEVEL
High(125 volts)
Low (100 volts)
High (425 Hz)
Low (375 Hz)
64.5 kva
FOR TRAINING PURPOSES ONLY
FlightSafety Canada
Generator Control Unit (GCU)
Each generator has its own generator control
unit to monitor, regulate, and control genera-
tor output. In conjunction with the other
GCU's, circuit protection and switching is
provided for the generator line contactors and
the generator transfer contactors.
The GCU will turn off the generator output if any
of the trip levels listed in Table 2-1 are exceeded.
Generator Line Contactor (GLC)
Each generator line contactor is responsible for
supplying its own main bus with power from:
• Its own generator through a generator
line contact; or
• A secondary source through a trans-
fer contactor
The secondary source is used only when the pri-
mary is unavailable. If power is not available
at either contact, the main bus is not powered
and the appropriate MAIN BUS OFF light on
the electrical control panel illuminates.
Generator Transfer Contactor
(GTC)
The GTC operates to supply power to the GLC
on demand. The priority of its sources are: (1)
the APU generator and (2) the opposite IDG.
TIME DELAY
10 seconds at 125 volts
0.1 second at 150 volts
L t é e
L t d .
4.25 seconds
0.1 second
3.5 seconds
6.5 seconds
CL 601-3A/R 2-3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Challenger 601-3r cl-600-2b16

Table of Contents