Evd Version; Evd Version With Display - Wega Polaris 1GR Use And Maintenance Manual, Instructions For The User

Polaris

12.2 EVD version

Place the cups to be heated on the cup heater
(2) and position the device switch located on the
machine's command facade (X) to ON.
Confirm that the light (16) on the front of the
machine is on, as it indicates that the cup-heating
system is active.
To adjust the cup heater, proceed as follows:
Upon the switching on of the machine, keep the
STOP/PROG. button on the right push-button
panel pressed: the flashing will point out the pre-
sent configuration of the cup heater according to
what is indicated in the design shown alongside;
Hold down the STOP/PROG. button until the led
on the keyboard changes from a flashing light to
a fixed one;
Press the key that corresponds to the desired
configuration;
Press STOP/PROG. button to confirm the opera-
tion.
80 °C
176 °F
Cup Heater
Disabled
To turn off the cup heater, set a temperature lower
i
than 70°C (the display will show ---- ) or position
the heater switch to OFF (it is located above the
machine's start switch)
For safety reasons it is advisable not to place cloths
i
or other objects on the cup heater surface (2) to
keep the machine from overheating.
52
STOP
PROG.
90 °C
194 °F
70 °C
158 °F

12.3 EVD version with display

Place the cups to be heated on the cup heater
(2) and position the device switch located on the
machine's command facade (X) to ON.
Confirm that the light (16) on the front of the
machine is on, as it indicates that the cup-heating
system is active.
i
To adjust the temperature of the cup warmer, refer
to the "Programming" section.
2 2
16 16
2 X
User manual