Table of Contents
Advertisement
Belt Adjustment:
The belt may come loose during transportation and/or stretch after prolonged use. To correct belt
issues reference the following situations for the appropriate actions:
1. Belt is shifting to the LEFT: turn on the main power switch of treadmill and let the belt run
at a speed of 1-1.5 MPH. Using the 6mm Allen Wrench provided, turn the left rear roller
adjustment bolt 1/4 turn in the clockwise direction. You should see the belt start to correct
itself by moving back toward the center. Repeat the above procedure until the belt is
properly centered.
2. Belt is shifting to the RIGHT: turn on the main power switch of treadmill and let the belt run
at a speed of 1-1.5 MPH. Using the 6mm Allen Wrench provided, turn the right rear roller
adjustment bolt 1/4 turn in the clockwise direction. You should see the belt start to correct
itself by moving back toward the center. Repeat the above procedure until the belt is
properly centered.
3. Belt is jerking or stopping when stepping on it: Turn off the treadmill. Using the 6mm
Allen Wrench provided, turn both left and right rear roller adjustment bolts 1/4 turn in the
clockwise direction. The turns of the adjustment bolt should be the same for the left and right
side during this process. Turn on the main power switch of treadmill and let the belt run at a
speed of 1-1.5 MPH. While holding on to the handlebars walk on to the treadmill to
determine if the belt is still slipping. Repeat the above procedure until the belt no longer
slips.
ADJUSTMENTS
17
Advertisement
Table of Contents
