BenQ EX800ST User Manual page 99

Hide thumbs Also See for EX800ST:
Table of Contents

Advertisement

Timing of replacing the lamp
When the LIGHT indicator light lights up or a message appears suggesting it is time to replace the
lamp, please consult your dealer or go to
lamp may cause a malfunction in the projector and in some instances the lamp may explode.
• The apparent brightness of the projected image will vary depending on the ambient lighting conditions, selected
input signal contrast/brightness settings, and is directly proportional to projection distance.
• The lamp brightness will decline over time and may vary within the lamp manufacturers specifications. This is
normal and expected behavior.
• The LIGHT indicator light and TEMPerature warning light will light up if the lamp becomes too hot. Turn
the power off and let the projector cool for 45 minutes. If the Light or Temp indicator still lights up after turning
the power back on, please contact your dealer. See
The following Lamp warning displays will remind you to change the lamp.
Notice
Order a replacement lamp
Equivalent lamp hour >XXXX hours
Order a new lamp at www.BenQ.com
Notice
Replace lamp soon
Equivalent lamp hour >XXXX hours
Order a new lamp at www.BenQ.com
Notice
Replace lamp now
Equivalent lamp hour > XXXX Hours
Order a new lamp at www.BenQ.com
Notice
Out of lamp usage time
Replace lamp (refer to user manual)
then reset the lamp timer
Order a new lamp at www.BenQ.com
"XXXX" shown in the above messages are numbers that vary depending on different models.
http://www.BenQ.com
Indicators on page
Install a new lamp for optimal performance. Press
dismiss the message.
It is strongly recommended that you replace the lamp at this
age. The lamp is a consumable item. The lamp brightness
diminishes with use. This is normal lamp behavior. You can
replace the lamp whenever you notice that the brightness level
has significantly diminished.
OK
Press
to dismiss the message.
The lamp MUST be replaced before the projector will operate
normally.
OK
Press
to dismiss the message.
before installing a new lamp. An old
102.
OK
to
Maintenance
99

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ew800st

Table of Contents