Table of Contents
Advertisement
If you are in a non-DHCP environment:
1. Repeat steps 1-3 above.
2. Press
/
to highlight DHCP and press
3. Contact your ITS administrator for information on the IP Address, Subnet Mask, Default
Gateway, and DNS Server settings.
4. Press
/
to select the item you want to modify and press OK.
5. Press
/
to move the cursor and then press
6. To save the setting, press OK. If you do not want to save the setting, press
7. Press
to return to Wired LAN page, press
press
/
to select On or Off.
8. Press
to exit the menu.
Controlling the projector remotely through a web browser
Once you have the correct IP address for the projector and the projector is on or in standby mode, you
can use any computer that is on the same local area network to control the projector.
1. Enter the address of the projector in the address bar of your browser and click Go.
2. The remote network operation page opens. This page allows you to operate the projector as if you
were using the remote control or control panel on the projector.
• Menu (
)
i
• OK
•
(
)
•
• Blank (ECO BLANK)
To switch input source, click on your desired signal.
ii
The source list varies according to the connectors available on the projector. ''Video'' stands for the Video signal.
/
ii
• Auto PC (AUTO) See
• Input (
)
•
(
)
•
to select Off.
/
to enter the value.
/
to highlight AMX Device Discovery and
i
Projector & Remote control on page 10
details.
Operation (under non-Launcher source)
.
for
77
Advertisement
Table of Contents
