Routers - Cisco ASR 9000 Series Installation Manual

Unpacking and Installing the Chassis
Removing RSP Cards and Line Cards from the Cisco ASR 9006, 9010, 9904, 9906, and 9910 Routers
This section describes how to remove RSP and line cards from the Cisco ASR 9006 Router, Cisco ASR 9010
Router, Cisco ASR 9904 Router, Cisco ASR 9906 Router, and Cisco ASR 9910 Router. The below table and
Table 11: Router Components and Slot Numbering for the Cisco ASR 9922 Router and Cisco ASR 9912
Router, on page
Table 10: Router Components and Slot Numbering for the Cisco ASR 9006 Router, Cisco ASR 9010 Router, Cisco ASR 9904 Router, Cisco ASR 9906 Router, and Cisco
ASR 9910 Router
Router Model Number Router Components and Slot Numbering
Cisco ASR 9006 Router
Cisco ASR 9010 Router
Cisco ASR 9904 Router
Removing RSP Cards and Line Cards from the Cisco ASR 9006, 9010, 9904, 9906, and 9910 Routers
92) and describe the router components and slot numbering for each router.
• 6 slots.
• Version 1 power system (Figure 85: Cisco ASR 9006 Router Components and Slot Numbering with
Version 1 Power System, on page
Router Components and Slot Numbering with Version 2 DC Power System, on page
• Two RSP cards installed in the two lowest slots (labeled RSP0 and RSP1) located above the power
modules.
• Four line cards installed in slots 2 through 5 above the RSP card slots.
• 10 slots.
• Version 1 power system (Figure 87: Cisco ASR 9010 Router Components and Slot Numbering with
Version 1 Power System or Version 3 AC Power System, on page
(Figure 88: Cisco ASR 9010 Router Components and Slot Numbering with Version 2 Power System
or Version 3 DC Power System, on page
9010 Router Components and Slot Numbering with Version 1 Power System or Version 3 AC Power
System, on page 83 for AC and
with Version 2 Power System or Version 3 DC Power System, on page 84
• Two RSP cards installed in the two center slots (labeled RSP0 and RSP1).
• Four line cards installed in slots 0 through 3 to the left of the RSP card slots.
• Four line cards installed in slots 4 though 7 to the right of the RSP card slots.
• 4 slots.
• Version 2 power system (Figure 89: Cisco ASR 9904 Router Components and Slot Numbering with
Version 2 DC Power System , on page
• One line card installed in the top slot (labeled LC1). Two RSP cards installed in the middle two slots
(labeled RSP1 and RSP0) located between the line cards (LC0 and LC1).
• One line card installed in the lowest slot (LC0) located above the power modules.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
82) or Version 2 power system
84), or Version 3 power system (
Figure 88: Cisco ASR 9010 Router Components and Slot Numbering
84).
(Figure 86: Cisco ASR 9006
83).
83), Version 2 power system
Figure 87: Cisco ASR
for DC).
81